I have not tried but thought i might interest some of you
Tags:
Tried it---
lots of stress on the 'ol hands and joints.
Wasn't evenly applied.
Had to be wiped, evened out and blended, using a rag.
Thanks Ill leave alone haah
Ken Darga said:
Tried it---
lots of stress on the 'ol hands and joints.
Wasn't evenly applied.
Had to be wiped, evened out and blended, using a rag.
Jens,
I've found that sprayer useful for spraying weeds, with a jet-stream setting.
Jens,
For inexpensive spraying equipment, I got better results using a pump sprayer.
Handy tool to apply sealer/stain on deck boards, landscape timber, wood mulch, and the like.
For doing lattice fencing, it's okay, but you're spraying a lot of open area---not much coverage for the amount of finish applied.
Went thru a quart of stain on only one side of a 4x8 lattice panel---not good.
After 1 panel, I went with the brushing method, on the remaining panels.
I needed to stain a section of wood lattice fencing, so as to match the finish on the deck and trim.
On a subsequent job, I went with the prefinished pvc lattice fencing panels---less expensive overall.
I had to try the pump sprayer method, so as to gain personal experience, for future reference.
Yes I did use pump up once on some lattice and it was fantastic. Could not have been any easier except dunking in a large tank and hang to dry hahah
Jens,
I hung the lattice fencing on the chain link fence, 'til the seal/stain dried.
Worked for me.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service