Kreg Owners' Community

Hi everyone : Has anyone purchased or tried the Incra I-box finger joint jig , looks pretty simple and accurate compared to my home made one that takes forever to get right.

Views: 513

Reply to This

Replies to This Discussion

I have the  Rockler sliding table jig about $60. It works well if your router table has a miter slot. Was able to make box joints on first try. Follow the directions and works great. 

I like the Rockler model ''box joint jig''---

intended for use on a router table.

Rockler Router Table Box Joint Jig

http://www.rockler.com/product.cfm?page=21338&site=ROCKLER

That's the one only box jig I have tried I was successful first try. Add a nice high fence and klamp the stock with kreg klamp good to go.

Gary,

How high was the fence you needed?

Gary roofner said:

That's the one only box jig I have tried I was successful first try. Add a nice high fence and klamp the stock with kreg klamp good to go.

I will take a picture of my setup. It comes with 3 sizes of box joints. I used the plastic trim white facia outside wood nice square and straight  .

I promised to take a picture of my rockler box joint jig with my fence .

Attachments:

Gary, 

How do you like the Bosch router table, pictured in your photo?

What are some of the advantages, you've find, that is to your liking?

Its compact and solid built however to high for my new workbench.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Rip-cut ACS plunge saw

Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue

Started by William Burt Brown in General Woodworking Mar 17.

Is the screw driver impact drill rater?

Is the screw driver impact drill rated?Continue

Started by Bob Naylor in Beginners' Zone Mar 10.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_