Comment
That looks good, nice job. I am planning to build something similar in the next couple of months
smart job matey....... thanks for the share
It was a challenge. I had to redo the back portion of the fence last night because my router came loose from the kreg plate slightly and started thrashing and tore out the grooves. I redid them and tried to drill a bunch of holes and then jigsaw cut but the drill bit tore out a lot in the backside. it didn't affect the front though so I left it as is. IN the future I will use a backer board so no tear out. It should work fine though. I dont have a drill press either so cutting the holes in the laminated sliding pieces was tough. I used a plunge rouger with a 3/4 inch dado cutting bit, it did ok, walked a little in one of the holes but not too bad. only notice it if you stare too long at it.
The router table is looking really good, your doing a great job thanks for sharing.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community