Good Morning again Community.
I was wondering if it would be advisable to hang my Garage cabinets that I am making using a 45 Degree bevel or French cut using 2x4's. I will be screwing into a cinder block wall. Like I said in my last posted question .... I am a new at this kind of Stuff.
Thanks So Much, Wayne
Tags:
I have mine hung on 1 x 4 French cleat
Thanks for the info Chip, I think that will probably work better. Wayne
There are some videos on Youtube showing French cleats. They make an aluminum French cleat that has a very low profile (less than 3/8 inch) but I have no idea where to buy it. I was given some on a construction job years ago. I used it to hang some board and batten shutters on my house this past summer.
Thank You R.E. for your response, I will look into that. I have seen them somewhere. This might save me some hassle because I don't have a table saw and I think just using a circular saw would be a mess.
Have a Great week!, Wayne
Are you planning on putting anything below the cabinets? Below mine that I built (check out my projects) I plan to add some tool board and so I fixed a 1 by 4 baton to the wall to sit the cabinets on which take the full weight. I then also screwed the cabinets to the wall at the top. The baton will be covered by the tool board (eventually) and to be provides a better option as it takes the whole weight of the cabinets.
Thanks Andy for your Help. Yes...Peg board and a Bench. I checked out your Projects and I think your Cabinets Look Great. A Real Professional Looking Job!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service