I wanted to use recessed LED light fixtures for my patio room, so I had to build a fixture to give me the room. When the ceiling is installed the will hang into the room about 2 inches, but the are very attractive
Comment
Designing and making the fixtures took almost 3 days, the LEDs are $49.98 at Lowes. So the fixtures were well over $100 each. Thanks for the comment Robert
Look like you have every avenue covered Hal,
I checked out the specs and you have selected a very good product, no price shown but I think mine were about $75 to $80.
After the installation I determined I had reduced my energy used for light consumption by about 48%
Robert
These LEDs pull right out and then you unplug them. They could be replaced by a standard bulb. The are very bright and dim-able. They are not little LEDs they are big ones. See:
http://www.lowes.com/pd_78215-3-70644_0__?productId=3334616&Ntt...
Hello Hal
I like your LED lights, they certainly provide effective illumination and look good.
I have a question for you, as I have some thing similar in my house, and from my experience LED lights are very predictable, they will fail on start up or fail prematurely ( before warranty expires) then fail as age related predictions approach (much the same as me!) so have you given any thought as to how are you going to service them after the ceiling goes in?
I would not want to be opening the roof to do maintenance on them if it can be done from inside with a pre install mod.
Regards
Robert Brennan
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community