Comment
Holy cow! How many computer screens does one guy have to look at all day!!
Looks good.
Paul I did this on the cheap. The stand or legs I did not build. I work at an old high school/middle school and being the new guy, I was tasked with finding furniture for my office. These are what used to be cubbies on the wall. They were actually 28 inches tall which gave me great height for a desk. The long desk dimension is 36" wide by 96" long. The short side is a simple 24"x48" sheet of plywood. I used birch plywood that I got from lowe's for 43 bucks for a full sheet and 17 for the 2x4 sheet. From there I cut 3 inch supports for underneath. I boxed in both sheets to make sure it was strong. From there I simply used a round over bit on all edges to get it somewhat smooth. In hindsight, I would buy some oak so that I got a cleaner edge that I was better able to route and sand. I will definitely do that next time. I am sort of limited in creativity as I don't have a table saw and my lack of skill saw skills leaves me with curved straight edges.... I used an ebony all in one stain/lacker (sp?) 2 coats did me fine. I want to make legs for it in case I ever have to move it, but not gonna attempt that until I have a table saw. If you have any other questions let me know and I will share my vast 1 project knowledge.... :0) Thanks for the kind words on the work!
Looks great. Do you have plans for it? My wife and I need new computer desks at home and this looks like it would work for us
You have done a great job Jayson, Looks good.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community