"That is an impressive amount of tools in a small space. My local goverment regulations say that I am limited to a 12x12 shed, I'm currently setup in my garage but it would be nice to have my garage back. I look forward to seeing your setup!"
"Thanks, I'm a big fan of simple design. The slats are not pocket holed, it would have been too many to fill. Instead I cut a groove in the top and bottom rail and then built the mortise around each slat."
"Thanks, I was a little worried to build one safe enough but after looking at the junk in the store this is stronger than anything I saw for sale. I'm hoping to have some more pictures soon, there are a few trim pieces I need to put on yet. He…"
K3 problem the threaded insert is lose and will not hold setting. The k4 is worn and hard to use. I was think maybe epoxy the insert in place may fix it. I tried wood glue did hold. Anyone else had the same problem? The k4 I have thought about…Continue
I'm thinking about getting the Kreg Miter Gauge instead of building a sled for my table saw. I figure the miter gauge would have more uses and since the stock will ride on the saw table there is no drop off like with some crosscut sleds. And it…Continue
I'm having trouble getting my pocket holes deep enough. I'm using the kreg j4 system and using 3/4" stock 1 1/2" wide. I have set my jig to 3/4" high for the stock and set my drill bit to 3/4" to the tip. I'm pretty new at using this and I thought I…Continue
I really like the Adaptive Cutting System (ACS) and hope to buy it soon. My table saw really scares me as I have a bad knee that likes to buckle on me at inopportune times. I can just picture it happening at the table saw and tossing me into the saw…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.