Started this discussion. Last reply by James P. Cottingham Nov 30, 2012.
I can't find any pan head screws longer than 1½". I'm in the middle of a project but could use some 2½", 2" at least:( Is SPAX a good substitute? By that I mean is the head small enough to fit in the…Continue
Started this discussion. Last reply by Troy Sep 6, 2012.
http://www.ptreeusa.com/edirect_081712.htmContinue
Started this discussion. Last reply by James P. Cottingham Aug 26, 2012.
I just heard a rumor that Kreg is handling distribution/support for Triton equipment. Anyone else heard anything? Would make a great match for the router tables.Continue
Started this discussion. Last reply by John Schaben Nov 18, 2011.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (2 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
It was the couple of doodads I was wondering about. What is the size of the face clamp? I purchased the 6" face clamp & right angle clamp. Mine also came with the vacuum adapter. I could see different picture on a couple of different websites but no explanation of what the other doodads were.
Thanks
Hello John, I am honored to be a friend, it seems you and I have much in the same ideas in the tech side of woodworking.
Thank you for the nice comments on the router post. Yes i agree with you on the long bits as the length needs to be considered too as they too will fool you on the amount of pressure that is exerted on them when speed is cranked up.
I will send you the bit review which is photos comparing the new bits against another well known bit. I have the set now and use it in my door stiles and rails As you probably know I build alot of doors so after testing the new bits my conclussion was that they were the bit for me. I see a definate improvement in the cutting performance.