I had this problem constantly since I am working in metric and thus had to adjust. My method is to set the stop collar on the drill bit 1/16" lower than it should be according to the charts. That makes the pocket hole bottom a bit…"
My 5 cents - the concealed hinges will hold the load, but what really would influence the number of hinges per side is the height of your door as the main factor.
The guide is, at least as I've been taught, to use 1 hinge per every…"
I've tried multiple, but one thing is to remember... The pilot holes for the screws are not often where the jig places them. You need to check with the hinge where to drill the pilot holes.
Other than that - all concealed hinges I believe…"
"I got it around October last year. Overall, a good buy, but I am really bummed about the fact it is VERY far from being flat, and not adjustable.
Did someone succeed to adjust the wings to actually be a flat 180 degrees, and no more than…"
My name is Ed, and I am from Sydney, Australia. Entered the woodworking world 2 years ago, and since then - flying ahead on a full steam! Kreg jig was one of the first tools I bought, and now I own quite a few of these blue devices,…"
First off tried to mention all this to Kreg via Email and just because I live outside the USA seems that the system does not work as they say phone number invalid, which is not.OK bought a Accu-Cut and set it up no problems there worked OK both…Continue
hi all can anybody help got r3 for Xmas and I have noticed that the gray tabs are different think somebody in assembly was talking the piss day and I have 1 metric side and imperial side so they don’t match up hellllp plzericContinue
I watched the setup videos, searched for information and spent half a day and can not get the clamp to hold.i tightened up the screws underneath in various stages up to fully tightened, makes no difference.I do not get the two clicks and I can slide…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.