Thanks for your interest. My table was basically copied from planes one developed and offered free plans from: Shanty-2-Chic.com I made my pedestal a little bit differently (2 X 6's) and the top is 2 x…"
"When Community members post photos and other content, they are simply showing off what they've created. They don't have to post plans, dimensions, etc. If you have questions about a member's posting, your best bet is to directly…"
"Are speaking of the round pedestal table? If so, I made the legs kind of on the fly. I wanted to make the pedestal square, so cut the rounded edges from 2 pcs of 2 x 6 making them 5" wide. Then I cut 2 pcs of 2 x 3 or 2 x4…"
Hi AllJust got myself a new Metabo mitre saw, kitted it out with a new Freud Pro blade as well as "pimped up" my bench with LED lighting so I can find stuff! I have 22 LED daylight tubes in my fittings in the garage so there is more than enough…Continue
I originally bought Ridgid tools for the warranty, well I had to replace batteries. Very easy and got new batteries and chargers. Found out they don't make 24 volt tools any more, so I sent in a hammer drill, impact driver and light for replacement…Continue
I am going to try and new project. Never made cabinets before. Researched and You-tubed like crazy. So many opinions. Mine are going to be:1 each= 30"W x 14"D x 38"H2 each =29"W x 14"D x 38"H1 floor to ceiling cabinet 18"W x 24"D and the height…Continue
Perhaps this question has already been asked somewhere on this forum but I wasnt able to find it after an hour or so of searching. Is there a recommended length of Kreg screw to use when combining a 1x6 into a 4x4 post. I have seen a few conversion…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.