Kreg Owners' Community

Bill Thomas
  • Male
  • Kennewick, WA
  • United States
Share on Facebook
Share on Facebook MySpace
 

Bill Thomas's Page

Profile Information

Which Kreg products do you own?
Kreg Jig® Master System, Micro-Pocket Drill Guide
How would you describe yourself?
Moderate Woodworker

Bill Thomas's Photos

  • Add Photos
  • View All

Comment Wall (2 comments)

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

At 5:30pm on September 29, 2010, Ed Morris said…
Hi Bill, Great job doing the wood joinery. I'm on Long Term Disability from the Royal Oak Burial Park here in Victoria, British Columbia, Canada. The only comment I have is that, any container that you put cremated remains in, is called a "Urn". I know that a Oak Urn from our park cost just under $200.00 Cdn, If you do not have the minimum size we use is 9" in length By 7" width By 4.5" height. If there is any concern if the Urn will fit the ash plot, just contact the burial park, where the ashes are going to be interned for the ash plot measurement and make your urn to fit the first time. Nothing worst to have when a family there and the ash plot is to small for the urn. I know first hand only to well. You can check out our burial park by going to. www.robp.ca Once again you did a great job. Ed Morris
At 2:53pm on September 23, 2010, Mike McGuire said…
Bill,
Very nice joints. I recently did my first dovetail project too but it was just a box, not nearly as detailed as the one you did. Did you use a dovetail jig or did you do it by hand? Very nice!
 
 
 

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_