You should be able to but it would depend on the condition of the wood used and how the crates are assembled. If the two pieces are not cut square, it could cause the joint to not pull tight or pull at an angle. Would you happen to have a picture of them? I would be able to give you a little better idea if it would work or not.
Thanks for asking for my advice, unfortunately I have only just purchased a kreg jig and am still trying to get the hang of it (a kreg virgin if you like lol). Sorry can't be more help, good luck on finding the answer to your question.
Kind regards Dave
K3 problem the threaded insert is lose and will not hold setting. The k4 is worn and hard to use. I was think maybe epoxy the insert in place may fix it. I tried wood glue did hold. Anyone else had the same problem? The k4 I have thought about…Continue
I'm thinking about getting the Kreg Miter Gauge instead of building a sled for my table saw. I figure the miter gauge would have more uses and since the stock will ride on the saw table there is no drop off like with some crosscut sleds. And it…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.