"See, I am not the only one admiring your craftsmanship Andy!!
I just looked up the Essential hardware website, man they have a lot of products. Was there a category under which the legs you made were found? Did you buy the corner brackets there as…"
"No plans - sorry - I really just kind of built it on the fly.The playing surface is 3/4 in birch plywood - I took two sheets 16" wide by 8 ft long and glued them to create the 1 1/2 thick playing surface. I then used fiberglass filler to smooth…"
"Hi Andy, I love your shuffleboard table!! Do you have any plans/drawings you can share with me as I would like to make one!! I live in Ottawa and am not familiar with Essential Hardware; where do you live?"
K3 problem the threaded insert is lose and will not hold setting. The k4 is worn and hard to use. I was think maybe epoxy the insert in place may fix it. I tried wood glue did hold. Anyone else had the same problem? The k4 I have thought about…Continue
I'm thinking about getting the Kreg Miter Gauge instead of building a sled for my table saw. I figure the miter gauge would have more uses and since the stock will ride on the saw table there is no drop off like with some crosscut sleds. And it…Continue
I'm having trouble getting my pocket holes deep enough. I'm using the kreg j4 system and using 3/4" stock 1 1/2" wide. I have set my jig to 3/4" high for the stock and set my drill bit to 3/4" to the tip. I'm pretty new at using this and I thought I…Continue
I really like the Adaptive Cutting System (ACS) and hope to buy it soon. My table saw really scares me as I have a bad knee that likes to buckle on me at inopportune times. I can just picture it happening at the table saw and tossing me into the saw…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.