"Ed, I down loaded a photo from the Internet. I think the wine rack was on wayfair.com I built a box 42x42", I used a 45 degree rabbiting router bit to cut the shelf angles but if you are good with table saw you can cut the 45 degree angles with…"
"Hi, my name is Allyn and I live in Canton, Michigan. I am retired and took up woodworking when my daughter asked me to build her 2 Adirondack chairs. I bought a plan and they turned out so well that I have made her 2 more chairs and I have made 10…"
Hi AllJust got myself a new Metabo mitre saw, kitted it out with a new Freud Pro blade as well as "pimped up" my bench with LED lighting so I can find stuff! I have 22 LED daylight tubes in my fittings in the garage so there is more than enough…Continue
I originally bought Ridgid tools for the warranty, well I had to replace batteries. Very easy and got new batteries and chargers. Found out they don't make 24 volt tools any more, so I sent in a hammer drill, impact driver and light for replacement…Continue
I am going to try and new project. Never made cabinets before. Researched and You-tubed like crazy. So many opinions. Mine are going to be:1 each= 30"W x 14"D x 38"H2 each =29"W x 14"D x 38"H1 floor to ceiling cabinet 18"W x 24"D and the height…Continue
Perhaps this question has already been asked somewhere on this forum but I wasnt able to find it after an hour or so of searching. Is there a recommended length of Kreg screw to use when combining a 1x6 into a 4x4 post. I have seen a few conversion…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.