Hi Everyone! I'm looking for some advice as to how to build and hang a vanity like the one in the pic. Would pocket screws be enough to hold it all together or should I put brackets in to help with load support? I'm kinda worried that someone using it may lean on it and it comes off the wall or wall bracket.
Tags:
Thanks Bill! I have an idea on the wall mount already, was just worried the screws wouldn't be enough to hold it together once mounted.
If you have a stretcher going across the back top and bottom, and as long as you are drilling directly in to the stud, it should hold. However, you may want to go a little more heavy-duty and use 1/4" lag bolts to hold it in place.
Thanks KregRep! Yes, that's what I had in mind for the wall mount part of it. My worry is the pocket hole screws holding the vanity together. Do you think those will be enough to hold not only the weight of the sink, but also if someone is leaning on it?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service