Tags:
Hi Rosemarie!
I mounted my K5 on my work bench using one short screw in each wing of the jig. If I need to move it I just pull up the two screws and I have my work space back. The two screws (one in each wing) holds the K5 nice and tight.
Randy
Good Morning Rosemarie;
If you go to Projects above and click on it then go to the search box just above all projects type in K5 then click on the search or hit enter the first project you see is the mount I did for my K5 this is portable so I can take it to the job or use it anywhere sturdy with the rubber I put on the bottom but also allows the unit to be easily stored out of the way if you have a small shop.i
Jeff
Good Evening Rosemarie;
Sorry my internet was down yesterday, first yes I did use pocket holes and screws to attach the oak banding around the edge in fact just to prove how good they are there is no glue normally I would use glue as well.
The 3\4 inch plywood can really be made any size you want it I wanted it to fit on the top of my Kreg assembly table the total width with the edging is 31 inches and the length from top to bottom is 23 inches you do not need to add the track I just wanted to make some longer position stops.
Hope this Helps
Jeff
Rosemarie Ratvasky said:
Randy, I'm sure I can find a few screws to get started. Thanks!
Thanks, Jeff! Nice setup -- you have a lot going on there. And thanks for the searching tip, too. I have NO shop as of now, just the picnic table on the patio. All I need now is some slightly cooler weather!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service