Considering making a cross cut sled for my table saw. So my question is...if you were to build one today...what features would you design into your build?
Tags:
...and a Merry Christmas to you as well!
Thanks Onno!! When you get a chance post a picture of it.
Merry Christmas to you as well!
Stan
Hello All and Merry Christmas!
Here are a few pics of the cross cut sled I made a few years back. I got the plans from ShopNotes Magazine's special issue "Tools & Jigs". This was one of my early projects and is mostly made from scrap. It has served me well and the ability to make 45 degree miters is real handy. As you can see the blade gets buried as you make the cut keeping hands well clear of the blade. Once you have used it for a while you know how far to push it across your saw to make a complete cut. The plans had the aluminum bar stock covered in PSA sandpaper to prevent slippage of the stock, but I have not added that. The fences slide along a kerf and makes it super simple to flip the fences for miter cuts. I would like to add a T track for a stop block, but I usually just clamp one in place. The toggle clamp was my addition though I do not use it much.
I didn't build it, but in the article they also include plans for a tenoning jig that slips into the same track as the main fences.
Cheers
Onno
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service