My trusty Kreg Jig and its uses!

Comment

Comment by Gwyn meredith on January 29, 2015 at 11:45am

Hi James ,I was impressed with your Krg jig you posted on vidio ,I would dearly love the dimensions to make this jig.i would like to introduce myself,my name is Gwyn ,I am Welsh and live in UK.Iam not sure if this forum operates this far.Look forward to hearing from you .
Regards Gwyn.

Comment by GARRY THERRIEN on January 16, 2015 at 8:56am

Thanks Mr. O'Rourke,

I'm going to start building a few cabinets so this will help a lot!

Garry

Comment by James O'Rourke on January 15, 2015 at 7:04pm

Mine is 48" long but that is based on using it for cabinets which can be more than 2' and I wanted it to balance as the board moves through the holes. It can be longer or shorter. Some changes I have made is I drilled a hole 25% larger than the bit at an  angle on one of the supports so I can just place the bit in the hole and it holds the drill. Make the fence the same height as the Kreg jig. Also the back part that has the areas for bits and screws is made based on scrap that I had. I actually don't put screws there very often because the jig is out of the way when I am screwing.

Comment by GARRY THERRIEN on January 15, 2015 at 9:09am

Hi James,

I would like to build this - what is the length of this?

Thanks

Garry

Comment by Bill Fleming on October 21, 2014 at 3:48pm

Very nice jig system you have,I might build this ,too