I plan on doing solid oak edge banding around the table top of a media console as well as on the adjustable shelves of the console. If I attach the solid banding with pocket screws, can I then route…Continue
Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.
My next build is an entertainment center consisting of both oak veneer plywood and actual oak dimensional lumber (mostly for face frame and hardwood edge banding --- not the iron on banding), both…Continue
Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.
Hi there everyone,I am hoping to purchase a Hitachi C12RSH 12" sliding compound miter saw. Most of my work gets done outside, as the garage I currently work out of has no electricity. I know this…Continue
Started this discussion. Last reply by Wendy Ratcliff Dec 30, 2014.
Hi Everyone,I am finishing up the construction of a bookcase/shelving unit (roughly hip height but wide), which is made of mostly (98%) pine (except for some pieces that were ripped from 2x4s [not…Continue
Started this discussion. Last reply by thomas b farrell May 19, 2014.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community