Kreg Owners' Community

Last Thursday I cut my drawer fronts all to Length (25 3/8") and drilled pocket holes in 8 of the pieces in preparation for putting 16 of the pieces togehter in pairs to make 8 panels I could cut to size for the bottom 8 drawers (my stock is wide enough for the top drawers).

Last night (Tuesday) I went in to glue up the panels and found that over the long weekend the pieces I had cut had all cupped, so none of them were flat. Luckly, I now have a 10" Jointer / Planer and I spend the evening flattening one face and one edge of all the pieces. Tonight I hope to run them all through the planer and get them truely flat, then I can finally glue them up.

I only hope jointing and planeing them will not make them so thin the pocket holes I drilled for 3/4" stock will still work.

Views: 41

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pocket Hole Drawer Slide Brackets?

Hello - I have a couple of workbenches in my 'shop' and am contemplating putting 2 or 3 pull out bins on the bottom shelves of both. I've not worked with drawer slides before and am looking to make it simple(r). Thinking of making 2 sets of pocket…Continue

Tags: hole, pocket, basket, slide, Drawer

Started by E M Hampton in General Woodworking Jan 10.

Kreg Jig 5 Clamp Busted 1 Reply

My clamp to hold boards to my kreg jig no longer works.  It won't move from it's spot and when I push the grey button on top, nothing happens.  are there replacement parts for this?Continue

Started by Tammy in Beginners' Zone. Last reply by John Browne Jan 3.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am — 2 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_