Check out this guy's modification to his K4! Not sure if this has been posted before or not.K4 with Foot Operated ClampContinue
Started this discussion. Last reply by Gary roofner Dec 5, 2013.
Hey everyone,I was salvaging some pocket screws from a project gone wrong that had been sitting outside, and I noticed some of the screws were a little rusty. They are the regular silver kreg coarse…Continue
Started this discussion. Last reply by Ken Darga Oct 14, 2013.
Hi all,I'm making one of the mudroom benches from the ana white plans for the "samantha entryway bench". You can see the plans…Continue
Started this discussion. Last reply by Ken Darga Jun 19, 2013.
We stopped by our local Lowe's and saw a Kreg Toolboxx Complete System in the Kreg area. It includes the K4 master system, the vac attachment, a work stop, the step and driver bit (both hex…Continue
Started this discussion. Last reply by Ken Darga Jan 3, 2014.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue
Tags: ACS
Started by Adam in General Woodworking May 6.
I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue
Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2022 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (2 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
Jason, thanks for your nice comment , I did buy the pattern from www.winfieldcollection.com for around $ 9.00 bucks and shipping . It is an easy build and you can adapt it to use the Kreg jig !!I have made five of them so far, good luck and hope this helps , the # for the pattern is cc26, there # is 1-800-946-3435, have fun , JIM
Jason, Where do you live? I only ask because just a week ago I was looking at a Dewalt exactly like this one including the wire hanging by the motor. I live in Eugene, OR. The place where I saw the saw had 2 of them plus 2 Craftsman saws. If you don't have one now & can swing it a sliding compound miter saw would be a better use of your dollars. The only things that I can think of that a radial arm saw can do thar a miter saw can't is rip & dadoo ( that looks wrong, sorry) LarryD