ready for sanding and final tuneup and lacquer

Comment

Comment by ray vile on February 28, 2012 at 11:42am

I like to use the wipe on poly from minwax also. it's so easy to use and it dries fast between coats

Comment by Jens Jensen on February 27, 2012 at 11:27pm

I'll keep this in mind However just about everything I build I sell.Now this is different however being it was my  trees that made the furniture.

Comment by Ken Darga on February 27, 2012 at 10:45pm

Jens,

If I were to keep this table outside, I'd seal the wood with ''Penetrol''---

peruse the product specs before proceeding.

http://www.floodaustralia.net/products/paint_additives/penetrol.php

Comment by Jens Jensen on February 27, 2012 at 10:27pm

I was looking at my stains today and found a Min natural .I keep all my stains in the house overwinter so I don't get a freeze out like I did in past,Ill give it a shot in morning. Do you lacquer over it then or leave alone

Comment by ray vile on February 27, 2012 at 9:55pm

Hi Jens, you might want to consider min wax's natural stain. I use it when I want the natural grain to pop out without really changing the color of the wood

Comment by Jens Jensen on February 27, 2012 at 9:29pm

Yes it  would be.But as much as I drink I did take that into consideration for weight factor. Been doing some sample stains on same wood today and I dont care for any of them. To dark even Golden Oak.So I think it will be straigt lacquer and lots of it

Comment by Ken Darga on February 27, 2012 at 8:13pm

Jens,

That would be a huge cup

Comment by Jens Jensen on February 27, 2012 at 10:39am

Just so it supports a cup of coffee is all I ask for. Thanks

Comment by Ken Darga on February 27, 2012 at 8:05am

Jens,

Nice heavy-duty looking bench.
It could support an engine block, during rebuilding. 

Comment by Jens Jensen on February 26, 2012 at 6:52pm

Ouchie. I wish he would have slabbed more than he did. But life continues down the  road

• ‹ Previous
• 1
• 2
• Next ›
• Page