Homemade K4 Jig using the R3 (Based on Plastic Stuntman's Design)

Comment

Comment by Wally on August 4, 2011 at 9:47pm

My apologies to Plastic StuntMan, but nowhere in these photos due I claim that this is my design. I did download your pdf but not using this site. I merely used your design and improved it in a couple of aspects, including the wider 2 x 10 base, the bolt and wingnut for holding the R3 and using a 1/2 in roundover bit on the base to clean it up. 

 

I thought that this website is for showing off projects that we have built (but not necessarily designed) using the Kreg Jig. I havn't seen any " I built this table using John Smith's design from such'n'such a website. They just say "Table built using the kreg jig".

 

I will change the name of the project to accredit you and your design. and I am sorry for "disturbing" you. 

Comment by Wally on July 10, 2011 at 1:49pm

Yeah it works great... the measurements on the side are for the different wood thicknesses, no different then using the grey sliders. I was wanting to make something similar to the K3 aswell but I just couldn't find a toggle clamp like that. If you know where I can pick something like that up, please provide a link.