complete counter

Comment

Comment by Michael Lester on August 28, 2013 at 7:48pm

Wow, very nice indeed!

Comment by Etay Schnapp on August 28, 2013 at 7:25pm

Once the hardwood boards were all glued and joined to the plywood base I used a 3 flute router trim bit to level the plywood to the hardwood so the sides are flush, then glue the siding piece and pocket join it from the plywood bottom (this was very close to the counter edge so I had to use plugs in the plywood as it would be exposed over the bottom cabinets)... then lastly run a 45 degree router bevel bit along the siding, fill gaps if any and sand down to 600...

Comment by Stanley C. Pearse on August 28, 2013 at 4:13pm

I will be starting to build a counter top later this week.  How did you go about making the counter top edge?

Comment by james wilhelm on May 27, 2013 at 7:15pm

Very nice design and finish , a job well done , thanks for sharing , JIM !

Comment by Damien Teal on May 27, 2013 at 5:14pm

Very nice!