Comment
The templates are a breeze to use, you just align them to either the top or bottom, put a center line on your work and align with the built in center lines on the templates, then use 2 4d finish nails to hold it in place, cut the majority off with the jig saw, then use a flush router bit with a bottom bearing so that you can trim it on the router table. Perfect every time, I actually used one of the templates to create the arch on my cross brace on the legs of my corn hole boards.
Good Luck,
Robert
hanks robert,
Looks like they have got to be the go, I wonder can I source them in Australia otherwise its a international purchase to Sommerfield I will do some research and see how I go.
Like the fact that they are the high density plastic,sure beats using MDF then Bandsaw and sanding etc, then I still had a rounded over corner so I was not impressed with my first result, too labour ebtensive and no repeatability,
Regards
Robert Brennan
Hello Robert,
I was admiring your door work and wondered how you came up with the curve in the top rails.
I have been making some doors but have been unable to find any details on Proportions, apart from the fact the stiles and top rail are the same width, and if there is a curve edge the thinnest section is the same width as the stile.
Hope your hand has recovered OK.
Regards
Robert Brennan
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community