Shop Projects

Comment

Comment by Ted W. Broussard on January 18, 2010 at 9:29pm

BTW: I built this table with no plans....just off the top of my head! I made some mistakes with the design. For instance, I decided on casters after I had built most of it and had to adjust my (then) Ridgid tablesaw higher to match the table. Once I purchase my SawStop, I had to cut it down and I have done that. I made the change with the platform. It is a cut sheet of plywood upon which the table now sits.

Comment by Clinton B Brewer on January 18, 2010 at 8:27pm

Nice; I would like to get a set of plans for a table set-up like this one.

Comment by gary j. cheadle on January 18, 2010 at 5:19pm

me too!

Comment by Danny W. Everhart on January 18, 2010 at 5:09pm

Would also be interested in the plans for this great work table...let me know as well

Comment by Ted W. Broussard on January 18, 2010 at 5:08pm

Brian, I would recommend that you get your hands on Fine Woodworking Issue #202. It features an outfeed table plan that is very similar to mine. As I mentioned in an earlier post, I had almost completed mine when that edition came out and was surprised at how similar the two were. I borrowed two ideas from that design. A shelf to store clamps and (you'ii see when I post the photo of my adjusted table (to accommodate my Saw Stop), the bottom platform.

I also do architectural drawings and, at some point, I would be willing to draw plans for this and make them available.

Comment by Brian Freed on January 18, 2010 at 10:15am

Do you have the plans used for this table? Would you be willing to share the plans if you have them?

Comment by Ted W. Broussard on January 13, 2010 at 2:39pm

Check out my Outfeed/Multi-Tasking table.