Raised Bed Garden

Comment

Comment by Mike Goetzke on May 31, 2015 at 9:26pm

I used a simple 2-D drawing program called DeltaCAD. I use it quite a bit. It allows you to print any scale required. If you look close I used a 1:1 scaled print to make one og the jigs. As you can imagine there was a lot of repetitive work. For the miter cuts I did these on my table saw and used my miter sled with stops to make sure all the cuts were the same. There were lots of pieces but planning the cuts and using jigs/stops/fixtures made quick work of them.

Mike

Comment by Jeffrey Chappell on May 31, 2015 at 7:49pm

love this. how did u determine what angles u need to make the round parts in the big boxes and for the center part