Comment
Hello Brian,
I hope some of the $150 you put into involved products to test that it actually worked mate!
Thanks, Brian, I'll look them over and come up with a sketch of my own as I go along. Nick
I added some of the rough plans if you want to check them out, if you have any questions I will try and help you out the best I can :)
Thanks, Brian, I'll be glad to look them over for some starting ideas. Nick
to be honest it was a lot of trial by error. I found a box someone made on a site without any dimensions at all. I had to just imagine and use stuff that was left over from old projects. I can send you the notes I wrote down along the way but again you will just have to use those crude drawings as a guideline and not true plans. Ive found when it comes to woodworking its always best to get ideas from other projects but put your own thoughts and designs into the project. This particular project I made for a charity event at my job for the Special Olympics. I put about 150 bucks into it and it auctioned off for $450.00 so not a bad deal :) I'll try and send you the drawings I made along the way to you.
Brian, I was wondering if you could share some info on your cedar cooler box construction and plumbing? What brand of coolers do you use? Igloo or Coleman? I've seen some links where the fella only uses Igloo coolers?? Do you disconnect the cooler lid from the cooler box? Any particular hints on how to do that without a lot of problems? Do you leave enough room inside the cooler box to remove the cooler or do you make the frame snug fitting? And then do you screw thru the lid to fasten it to the cedar box lid? Finally can you give me a little insight on how you attach the brass drain fitting to the cooler box inside? Thanks, Nick
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community