I ripped a 2x4 board to be a true 3” instead 3.5”. The thickness of the board remains 1.5”. When I put the pocket hole in the board, the top of the hole was too high and now visible. In other words the top of the pocket was on the top of the board instead of fulling concealed on the side.
This might have been discussed before but I can't find the right answer.I recently upgraded to a Kreg 720 Pro and gave away my old R3. The old kit had a chart in inches & mm for setting the collar depth of the Kreg pocket hole drill.…Continue
Hi everyone,Just got my 720 jig. I noticed that when I put the drill bit into the drill guide, it does not go through. The tip of the drill bit does not extrude from the guide. A photo is attached.I wonder if it is normal, because if the bit does…Continue
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…