I have a K4 Kreg Jig Master System. With the Dust Collection Attachment in place I find it almost impossible to loosen/tighten the brass (?) knurled screw (Drill Guide Pin) that holds the Drill Guide in place at the correct height setting, and I find removing the Dust Collection Attachment for each adjustment to kind of a pain.
If Kreg was to sell a replacement Drill Guide Pin with a square drive inset added - which would allow me to use the screw drive bit to loosen/tighten the Pin - I would buy it in a heartbeat!!!
Tags:
Ken,
Thank you for the suggestion. Unfortunately we do not offer a pin like you are referring to at this time. If you are having issues with removing the pin, you can try slightly lifting up on the drill guide block as you rotate the pin relieving the weight against it. This should make it much easier to turn allowing you to loosen it easier.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service