Tags:
Hi Dave - I've sprayed Behr Ultra Premium Plus gloss paint to finish up some trim when I painted the house last summer. I did most of the house with a Spraytech airless but had a few feet of trim around one porch to finis so I thought I'd try it.
I did have to thin it quite a bit. I was at about 5% or so with Floetrol for the airless so I added some more floetrol and then bottled water until I got good atomization. May have been up around 20% + diluted. That thin I did have to go back over it several times, maybe 5 or 6 but ended up with a very nice finish. Rather than risk runs, I just sprayed it on and if it covered OK, if not, OK too. When I got to the end I just went back and did it again. Small area, about 30 ft of window sills and trim, It flashed off and was ready for recoat in about 5 minutes so recoating wasn't a big deal. I think I will be planning an upgrade to the unit though, definitely not up into the $1000 - $1500 range, way to rich for my blood.
I've heard a lot of good things about the Fuji Mini-Mite, 3 stage for $550 or so.
DAVID CZUPRYN said:
Hey, John!! That's what's stopping me too. You're exactly right. A five stage Titan is about $1600.00 or so,as is Graco's five stage. Add some accesories, and round about you're at $2000.00 bucks !! I can't justify the cost. A three stage goes for about $700.00 or so. That's not as bad. I might be ok with that, provided I stay away from heavy latex. What are your thoughts about that? Thanks,Dave
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service