Kreg Owners' Community

I am attempting my first project designed to actually be used in the house.  I am building a bookshelf out of 3/4" birch plywood and would like to use a small roundover bit to smooth the edges.  Question I have what time do I use the veneer on the plywood edges?  Before or after I round the edges?

Views: 357

Reply to This

Replies to This Discussion

Hi Scott,  In answer to your qustion about the veneer application.  If you are talking about using the iron on or stick on veneer that is thin you will want to apply the veneer before you use the round over bit.  If you don't then you will have to cut the veneer to fit the plywood edge round over.  The veneer will then have to be trimed off using a knife or sandpaper of both. 

I would think seriously about ripping some solid birch lumber down to like 1/4" thich and glue it on.  Then you can then round over the material with the router bit.  You will find this to be a better method than using veneer.  It is more durable in the long run.

Thanks for the help with the veneer.  Also didn't think of ripping birch lumber for the purpose ... to bad I don't have access to any where I live.

I agree with Jay but if you can't find birch in your area I have used maple to edge birch plywood in the past with some good results

I've done just that. Taken a small piece, routed the trim I wanted and use some glue and a pin nailer. Looks pretty decent. Just remember to clamp it down and keep the top surface flush. I used paint so I was able to get away with poplar wood.

Even if you put the veneer on first I don't see how you wont cut into and expose part of the core with a round over bit. Maybe it's possible, I'm not sure

There is a video that kreg sells on cabinet making. He talks about using a bullnose and sticking it to the counter top. He uses pocket screws but that's overkill in my opinion. Pin and glue has worked really well.

Are you using a face frame?

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation 1 Reply

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone. Last reply by Scott Davison Oct 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_