Kreg Owners' Community

I've got another question, sorry but now that I have people to ask, theres a lot of little things I have wanted to ask but felt I should already know so I didn't ask. When I make something square, using miter cuts. one side will always be off. when I measure it out it works on paper, but when I cut it the ends don't seem to match up. Do you measure the inside or the outside of the cut.?

Views: 303

Reply to This

Replies to This Discussion

Hi Charles, cutting miters can be tricky and requires careful measuring and accurate set miter saw.  You must also have exact width of stock.  When I cut a miter I measure from the inside as accuracy of a miter becomes less accurate with distance.  This is the problem with miter saws that  are not accurate as when you move the saw changing from one side to the other accuracy is destroyed.  Meaning that the miter saw will cut the same angle when repeated over and over again but when you change to the opposite side the angle is now effected by the accuracy of the saw.

If I am cutting miters on flat stock I cut all my miters from the same setting and do not move the saw.  Do this by flipping the stock rather than changing the saw from side to side.  Since you are inquiring about a table saw the same principals apply. 

thank you, I will give it a try.

repeatable accuracy is inherent in the quality of the saw. I can swing my dewalt compound sliding saw back and forth all day and get very consistent accuracy. if you want to get technical get a good table saw with a miter attachment and build a sled for it.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone Jul 22.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_