I mounted my K5 on my work bench using one short screw in each wing of the jig. If I need to move it I just pull up the two screws and I have my work space back. The two screws (one in each wing) holds the K5 nice and tight.
Good Morning Rosemarie;
If you go to Projects above and click on it then go to the search box just above all projects type in K5 then click on the search or hit enter the first project you see is the mount I did for my K5 this is portable so I can take it to the job or use it anywhere sturdy with the rubber I put on the bottom but also allows the unit to be easily stored out of the way if you have a small shop.i
Good Evening Rosemarie;
Sorry my internet was down yesterday, first yes I did use pocket holes and screws to attach the oak banding around the edge in fact just to prove how good they are there is no glue normally I would use glue as well.
The 3\4 inch plywood can really be made any size you want it I wanted it to fit on the top of my Kreg assembly table the total width with the edging is 31 inches and the length from top to bottom is 23 inches you do not need to add the track I just wanted to make some longer position stops.
Hope this Helps
Rosemarie Ratvasky said:
Randy, I'm sure I can find a few screws to get started. Thanks!
Thanks, Jeff! Nice setup -- you have a lot going on there. And thanks for the searching tip, too. I have NO shop as of now, just the picnic table on the patio. All I need now is some slightly cooler weather!