Hello, has anybody in Australia managed to get hold of the Kreg KWS1000 Mobile Project Centre? I have tried Amazon but the freight was more than the tool cost and the local distributor, Carba-Tec don't have it and are't interested in helping. I assume this might change when Amazon open in Australia but that won't be until 2018.
Thanks.
Lee.
Tags:
Hi Brad,
It was a 135 degree plain twist drill. Not as good as a counter-bore but it allowed the rivnuts to be flush.
Roger
I got it around October last year. Overall, a good buy, but I am really bummed about the fact it is VERY far from being flat, and not adjustable.
Did someone succeed to adjust the wings to actually be a flat 180 degrees, and no more than that?
Thanks!
Edward,
The table top is not designed to be a completely flat surface. It is designed to be a working surface and not a flat surface to be measured against. While clamping your work pieces the material will be flat against the table and will not cause issues with your joint. With this being said, the table should not dip more than 1/4" from the center of the track to the edge of the table. If it is more than this please either contact us directly or the dealer you purchased it from.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service