Kreg Owners' Community

Hello, has anybody in Australia managed to get hold of the Kreg KWS1000 Mobile Project Centre? I have tried Amazon but the freight was more than the tool cost and the local distributor, Carba-Tec don't have it and are't interested in helping. I assume this might change when Amazon open in Australia but that won't be until 2018.

Thanks.

Lee.

Views: 977

Reply to This

Replies to This Discussion

Hi Brad,

      It was a 135 degree plain twist drill.  Not as good as a counter-bore but it allowed the rivnuts to be flush.

Roger 

I got it around October last year. Overall, a good buy, but I am really bummed about the fact it is VERY far from being flat, and not adjustable.

Did someone succeed to adjust the wings to actually be a flat 180 degrees, and no more than that?

Thanks!

I am loving my work centre. True, the top isn’t flat but I wouldn’t expect it to be. It folds after all. The self adjusting clamp that comes with it is a real timesaver for me. I have since bought the Kreg accu cut and the rip cut jig. I find the method of attaching the saw to these to be truly awfull so I have the saws permanently with 5mm screws. I guess I don’t expect things to be 100% every time because they never are no matter who the manufacturer is.

Edward, 

The table top is not designed to be a completely flat surface.  It is designed to be a working surface and not a flat surface to be measured against.  While clamping your work pieces the material will be flat against the table and will not cause issues with your joint. With this being said, the table should not dip more than 1/4" from the center of the track to the edge of the table.  If it is more than this please either contact us directly or the dealer you purchased it from.  

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Accu-Cut XL track alignment issue 1 Reply

Hi All,I'm just wondering if anyone else has had this issue and can help me,I recently purchased the Accu-Cut XL and when I went to put the track together I noticed that one of the tracks was different to the others The alignment of the track guide…Continue

Started by Al Barale in Community-Specific. Last reply by KregRep on Tuesday.

Advice on assembling the "offset" bottom of a wall cabinet

Hi,I'm about to build my first wall cabinet, using 3/4 plywood for the box and 1x2s for the face frame. Everything will be assembled using pocket hole joinery. I've attached a basic image of what the cabinet box will look like.I'm planning to have…Continue

Tags: cabinet, holes, pocket

Started by Jeff Welsh in Beginners' Zone May 26.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_