I've done a few small projects with Kreg tools before, but this will be my first custom undertaking and I'd appreciate any advice.
I'm making a coffee table from two sheets of Ikea "Lagan" countertops (See here for the specs: Lagan). I've used these before for a desk and they are cheap and sturdy. Attached are the sketchup file and a couple screenshots...
Specifically, I'm looking for advice on doing the pocket holes with the mitered joins. The angles are all 30 degrees. I'm just wondering if there's anything I should look out for, or do differently than if I was doing a normal 90 join with pocket holes. The only joins I'm really worried about are the side to the bottom panel. I think I've planned it well so that it will be strong and the pocket holes will all be internal and easy to screw in place if done in the right order. I'll join sides to bottom, then center supports to top, then top to sides, then screw center supports in from the bottom.
Also looking for advice on legs! Anyone have any creative ways to join legs with pocket holes in a project like this?
Thanks so much for your help!
Tags:
I'm by no means an engineer, but the joints you mentioned on the bottom appear to be problematic to me. Pocket holes from the inside of those joints definitely won't offer much strength. I would also reverse the joint where the top meets the end pieces. The pocket hole would need to be on the outside of the acute angle in either instance, but this would put it in the end and would have the ends supporting the top better.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service