Hi everyone,
Thought I would ask this here because everyone is so knowledgeable and helpful.
I was setting up my miter saw (Harbor freight 10in sliding) and after alot of adjusting of the fence (which I think was not machined 100% strait) I finally got it square to the blade on both sides (checking with an accurate combination square) and square to eachother across the length of the fence (with a strait edge level), this was more challenging, and sealed the bolts with threadlock. Checked the blade bevel and was dead on out of the box. Next I checked the cut/miter gauge with the following method
http://www.thisiscarpentry.com/2010/07/23/miter-saw-tune-up/
I finally got the saw on point, however a true zero is a little to the right of the detent/automatic stop. This is annoying because I can easily shift to my true zero because it is not tin the automatic stop/detent. Anyone else with this problem? Any advice on what I should do? The miter gauge/scale is not adjustable you can just move the pointer. Thanks for any help.
Tags:
I seen that on youtube the other day and they real get in to it if that helps.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service