View
Discussions Replied To (3) | Replies | Latest Activity |
---|---|---|
"Thank you, for the comparison pictures, they look great. There is no room for confus…"KregMS replied May 31, 2012 to Introducing the Kreg Jig® HD |
87 |
Dec 19, 2014 Reply by Ken Darga |
"No, I didn't misunderstand. Would you use a fine thread inch and a quarter screw to…"KregMS replied May 31, 2012 to Introducing the Kreg Jig® HD |
87 |
Dec 19, 2014 Reply by Ken Darga |
"I'm in no way taking anything from your new HD System (jig, Screws, ect) However: I…"KregMS replied May 27, 2012 to Introducing the Kreg Jig® HD |
87 |
Dec 19, 2014 Reply by Ken Darga |
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service