Hi guys.
I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?
I actually have a couple of questions:
Firstly, should the drawer slide fit flush with the bottom of the drawer?
(That seems to be how the jig would fit it)
I need the base of the drawer to sit 13mm above the floor of the wardrobe, but the jig sets the drawer slide at 100m.
So do I need to create a home-made jig (13mm wide length of ply on each side) and use that instead, or is there a way to use the jig?
Or could I place the drawer slide at 100mm (each drawer-box is 200m tall), but if I do, then how do I align the middle of the drawer to the slide?
(Thinking about it, do I turn the jig around and clamp it 87mm below the 100mm slide line for the 13mm gap that I need?)
Sorry to ask complete numpty questions, but I 'm new to the big project work and I want to know what the more experienced users do for this type of situation?
Thanks in advance.
Craig
Tags:
Craig,
It would be a lot more helpful if you where to post some photos of what you are talking about and i am sure some body will be able to answer all your queries.
regards jock
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service