Picked up a K3 today on CL for $50. Very slightly used, came with drill bit, drivers, etc., plus an almost full box (500) of 1 1/4" coarse screws. (bought it from a young man who apparently didn't know what he had(:)
I already have a K4, purchased it in '08, and use it often. Question is, what does a guy do with 2 of these? The K4, I keep it on a shelf when not in use, and when I need it I just clamp it to my work bench, simple, space saving, and effective.
The K3, I see I will have to mount it to a board and then clamp the board to work bench surface.
I'm a shop jig and gadget guy so am looking for ideas to justify having 2 of these wonderful "gadgets".
Tags:
...and the Master Collection Kit includes the screw selector guide ''wheel''.
Rockler is offering $50 rebate, for the Kit!
Gary roofner said:
You could buy that $300 tool box and get a K3.
A major issue I have with the Kreg 4 is not being able to work on large panels (like for kitchen cabinets). You cannot reach around a large panel to clamp it into place. You have to walk around the bench, if you can walk around the bench, to clamp the wood and then walk back around to drill the hole. With the Kreg 3 you clamp and drill on the same side of the wood. II am just completing some base kitchen cabinets and did not use Kreg joinery because of this issue. I dadoed instead. I only Kreg'd the face frames.
You could buy that $300 tool box and get a K3.
Sounds like you really like that screw selection wheel.
Paul Jones said:
Also the screw selection wheel.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service