I just purchased the Kreg Jig, and was excited about using it. However, when I went to set it up out of the box, I can't get the dril guide to release from the base. It won't even move. It's like it's built right to the base. The DVD or booklet were not helpful. Any suggestions?
Tags:
Are you talking about the depth setting guide or the guide for drilling?
Mine has the brass screw, but it was in a seperate bag, not attached to the drill guide at all. There is a brass insert in the drill guide for the screw to go in to tighten the drill guide once in place. However, I do not see anything else holding that drill guide in place, yet it won't budge. It will not allow me to change the thickness settings.
The drill guide itself, the piece you actually insert the drill thru.
Hugh Clare said:
Are you talking about the depth setting guide or the guide for drilling?
You saying the "drill guide block" is stuck in the "base", right?
I would take it back and get another one. But if you got it online then shipping charges will cost you, unless you contact the company and let them know your situation and see what they can do.
Other than that you may have to use something to force it up through the base. Maybe KregRep can give you a better solution to help you solve your problem.
Any chance you could post a picture? It could be something recognizable on sight.
m.brown,
The ''drill guide'' is the metal tubular object, ''permanently'' affixed into the drilling jig.
It's purpose is to ''GUIDE" the drill to the work piece, at the appropriate angle.
Where in the instructions does it state to remove the drill guide?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service