Tags:
Hi Larry - you could square it up by playing with the screw tension but you would be sacrificing joint tightness. You would also need to make sure your design had plenty of redundant bracing to ensure rigidity and I don't think glue would be optional. You may also be able to "cheat" a bit with shims. To follow your thoughts, put the first screw in the tight side and make sure it is tight. Square it up and shim the "loose" edge and put in the second screw tightly. Trim the shim leaving part in the joint.
Thanks John for the suggestion. Clearly square cuts are very important just as getting the right lengths are. I will work on my accuracy and maybe that is the only way to square up a frame if one is using the pocket hole technique. I was hoping there was another way in the case where the cut is a little off. For example what if I only joined each joint with one screw and did not pull it tight. Then couldn't I check the square just like I would if I was not using pocket holes, or would the frame just move when I went back and added the second screw and pulled the screws tight?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service