Started this discussion. Last reply by Tim Roman Dec 18, 2012.
Started this discussion. Last reply by Ken Darga Nov 11, 2012.
Started May 15, 2011
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (12 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
arevee1@aol.com
Hi Kenny,
I must of just missed you guys last night, but I read about your wifes problem with her knee. If it makes you fell any better let her know I had both mine replaced and I would do it again in a heartbeat. I didn't have any problems at all, and just a little bit of pain, but you have to do the therapy afterwards
Ray
thank you kenny. i'll get back to you with some stuff
Kenny,
Keep in mind that the depth of the hole being drilled also has to compensate for the different screw lengths. Although the depth might be different than you think in some cases, this is simply because the recommended screw for that particular application has changed as well.
KregRep
View All Comments