I bought 2 of the 3-inch versions to be used on my drill press table. It's difficult to explain the problems, but I'll try. First, there are no written instructions - except for a tiny, itty-bitty…Continue
Started this discussion. Last reply by Chuck Decker Oct 13, 2013.
I am moving, and I need to buy a shallow, flatbed trailer for hauling plywood, etc. The problem is that the garage is too small to store the trailer and two cars at the same time. So, I am trying…Continue
Started this discussion. Last reply by Chuck Decker Apr 9, 2015.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue
Started by William Burt Brown in General Woodworking Mar 17.
Is the screw driver impact drill rated?Continue
Started by Bob Naylor in Beginners' Zone Mar 10.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community