Ok, just to let you know. I don't know one end of a bit of wood to the other !I need to build a loft bed for my 14yr old daughter for her new small room.would 30X70mm be large enough to make it out…Continue
Started this discussion. Last reply by Michael Scott Denny Mar 27, 2020.
Hi there I'm a complete newbie to wood working.I would like to build a set of draws for my computer desk, was looking at …Continue
Started this discussion. Last reply by Don Foley Oct 18, 2016.
BTW, I doubled up on the four corners. I ripped two 1-1/2" pieces of poplar and glued them together. That would have made them 1-1/2" square corners. Here is a pic of the glue-up of the corners.
Hi Chris,
So sorry that I haven't been able to get back to you and answer your question. I was too busy painting the exterior of my home. It took me two months! I'm now working on one of my bathrooms.
At any rate, I used 3/4" poplar for everything except for the three walls of the drawers. I used 3/4" pine for that. For the drawer bottoms, I used some kind of smooth plywood, but it wasn't plywood. It sold in 4x8 sheets, and it was 1/8" to 3/16s" thick. I would never use 1/4" regular plywood for the drawer bottoms. Too thick for me. I also used wooden drawer slides from Lee Valley Tools at $5.80 per.
I hope that helps! If you have any more questions, just contact me.
Zac
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service