For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue
Started by Ken Kortch in Kreg Jig® Operation Oct 11.
I have an old Rip-Cut which I bought many years ago but did not set. I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue
Started by Sean in Other Kreg® Products Oct 4.
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…Continue
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am