Kreg Owners' Community

Not just the Voice of the KREG Jig, but a Happy Customer too!!

I had someone hit my blog and recommend I post something here on the KREG Jig site. Sure. Earlier this year, we just did another session where I was the voice for the Kreg Jig infomercial playing around the country. Not the on camera stuff, but the voice work between the shots, and the commercial too. Been doing that for 2 years now?

I just did my first project for our very Italian house we GC's back in 2007. Peggy, my wife, wanted open shelving above the washer and dryer for over 2 years now. So I broke out the KREG Jig and went to town!! We laid out the design and then stained and finished the shelves BEFORE we put them up... saved a lot of time of not having to mask off and stink up the house.

Here's the blank wall:


Laying out the shelving:


Installation:


Two AFTER shots.


Views: 90

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Jim Kipping on November 11, 2009 at 9:33am
Derek, yea, I did those on the top as you will never see them, unless on a ladder. We chose to fill the holes with a color wood filler/puddy. Thanks sir. I need to move on to A kitchen cabinet, and the wine room storage in the coming months. I really want to start and get my outside kitchen going complete with outside pizza oven.
Comment by Derek on November 11, 2009 at 9:23am
Are the pocket-holes on the top side? If so, I'm assuming you used pocket-hole plugs?
I like the end result. Cool.
Comment by Bob Farmer on November 10, 2009 at 3:54pm
Very well done! A personality and a talent! Thanks for sharing your photos.
BTW, your voice might have convinced me to get a Kreg Jig! :)

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_