Kreg Owners' Community

It's been a slow week on the faceframe project, I'm at the point where I have to move the stuff into the house and acutally install the frame, and I need a full day to tackle that, not just the hour a night I spend in the shop.

I did notice however that my Kreg tools were laying all over the place, so they finally got their own toolbox.

Views: 463

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by KregRep on August 31, 2009 at 11:04am
How about the other Kreg Jig Owners' Community members out there... where do you store all of your Kreg tools? Do you have a specific toolbox or is everything in different locations? Lets see some photos!
Comment by Joe Luberto on August 28, 2009 at 3:54pm
Kerry the tool box is a good idea.By the looks of it, your going to need a bigger tool box. I've noticed you keep getting more and more kreg tools,which is not a bad thing.
Comment by Derek on August 28, 2009 at 2:20pm
I like how organized it is. I want one.

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_