Hi there.
I've bout the Kreg Right-Angle Clamp about two months ago and thought to give my two cents take of it for a change. I strongly suggest to make the pin side of the clamp a bit thinner. My problem is that with the standard drill bit that come with the Kreg 5 Jig it is a bit too think and Especially with soft wood (but not only) it tend to rip the hole, now I've just ordered the Mini jig attachment and absolutely sure it will basically be…
ContinueAdded by PJ on August 31, 2014 at 5:30pm — 7 Comments
I'm an amateur/beginner woodworker. and just in the process of acquiring tools. I've just got the K5 and stated working with it and so far so good. I'd like to see 1/2" size screws and matching size in the sizing jig, for thinner boards. as improvement, but other then that I am very happy with it in contrary to the Multi-Mark Measuring tool. which has nice concept but unfortunately I like many others complain about the tool not being tight when measuring 90 degrees, and it has a few…
ContinueAdded by PJ on July 22, 2014 at 4:07pm — 8 Comments
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service